Do those high pressure direct injection motors hold up, or are they like the mercury optipops?Be a nice little boat with a repower
As long as it passes the sniff test
Do those high pressure direct injection motors hold up, or are they like the mercury optipops?Be a nice little boat with a repower
As long as it passes the sniff test
They have a good rep but that's an old engine. Things like a trim pump can cost more than an old engine is worth often, and any engine can go booM after that longDo those high pressure direct injection motors hold up, or are they like the mercury optipops?
Don’t know don’t care might be a fine engine why take a chanceDo those high pressure direct injection motors hold up, or are they like the mercury optipops?
I had 3200 hours on my last set of “optipops” when I re powered…lolDo those high pressure direct injection motors hold up, or are they like the mercury optipops?
When “cushioned seats” are an option they listed I’m not sure how many are left…Nice looking 18 foot 2006 silverstreak hull and trailer, with some older motors. At 45k I'm not sure I agree " to many options to list." https://www.facebook.com/share/19TfcMCGa3/
So motors probably worth 8 grand.. trailer 2.... how much does that hull weigh, and what's current aluminum scrap value, add those numbers up and you get fair market value... that or find some clueless surveyor to value it stupid high and insure it so you can win when it eventually sinks at the dock... hope it's not a members boat, but ever members boat that's been a riverhawk/rh has ended up ending with pictures of it under water....Good looking deal. Lots of details. If it checks out should sell in days https://www.facebook.com/share/15Yggbas3A/?mibextid=79PoIi
View attachment 112321
19.5 Welded Aluminum Center Console with Trailer
1999 Riverhawk Marine welded aluminum center console, 22.5 LOA, hull is in great condition no damage.
Dialed and ready to go - Bimini top, swivel front bucket and 2 bench seats - this boat feels quite big for its size and easy to move around on. Easy to trailer and launch as well.
2014 Mercury 150 XL with 208 hours, all services complete, stainless prop, runs like new.
Yamaha 9.9 kicker with full console controls - reliable, unknown hours, full service just completed
Simrad NSS chart plotter
Anchoring system
Raised welded aluminum platforms for riggers with rod holders with Scotty swivel/tilt bases and wired for Scotty both sides, ample rocket launcher racks on structure
Boat has undergone a refit at the end of 2023
New batteries (2022)
New bottom paint
New upper paint
New Bennet trim tabs
New LED navigation lights
New auto bilge
New fore and aft flood lighting
New bus bars
New compass
New solar trickle chargers
New low voltage charging station on dash
Trailer: Galvanized Tricker Trailer with folding tongue for compact storage
Upgraded end of 2023:
All new LED lighting
New alloy wheels and tires
New winch
New HD tongue jack
LOCATED ON THE SUNSHINE COAST
Viewings must be scheduled Fri-Mon
Boat is currently on the hard
Member or not it’s a factSo motors probably worth 8 grand.. trailer 2.... how much does that hull weigh, and what's current aluminum scrap value, add those numbers up and you get fair market value... that or find some clueless surveyor to value it stupid high and insure it so you can win when it eventually sinks at the dock... hope it's not a members boat, but ever members boat that's been a riverhawk/rh has ended up ending with pictures of it under water....
Do those high pressure direct injection motors hold up, or are they like the mercury optipops?
What link are you referring to?If it only needed a motor famous last words
Add trailer and a major refit, wiring, tank and fuel lines, kicker, electronics through hulls re and re and If no rot found plus canvas and cushions
Pricey little project
And burn up a bunch of time at $
when you need a trailer to put your trailer on to haul your boat I’ll think not
Then again what do I know just a land lubber