Tightlines22
Well-Known Member
Help! I am trying to get the cap off my Yamaha 200 tilt tube as I need to replace the seals and o ring. Getting a few drops of fluid leaking every time I tilt it up.
I have the Yamaha tool with pins to fit the holes in the cap. Just can't seem to crack it off. It looks like the factory seal as it has the Yamaha paint on it so that may be why it's is being a !:"! to get off.
I have put penetrating oil on, ran a blade around edge to get oil in there and tapped it with a hammer as much as I can. And even put my paint gun on the cylinder to heat it up a bit. No go! Any suggestions?
I have the Yamaha tool with pins to fit the holes in the cap. Just can't seem to crack it off. It looks like the factory seal as it has the Yamaha paint on it so that may be why it's is being a !:"! to get off.
I have put penetrating oil on, ran a blade around edge to get oil in there and tapped it with a hammer as much as I can. And even put my paint gun on the cylinder to heat it up a bit. No go! Any suggestions?