1/8 for the skin. Probably have to move the splash well forward but hoping not tooSkill saw with a finishing blade works great for AL as well sometimes easier to keep straight than the jig. Good luck on the project how thick are you going for the transom?
How far from shore have you been so far? There’s already contour detailing within a certain distance from shore but if you’re gonna get out further, you might need it.Went for my first burn in 6 months. Ran like a topGot her up to 48Mph.
really impressed with the detail of the Garmin map out of the box. I don’t see a need for a map chip. @Aquaholic
Everything is amazing except it’s taking lots of turns of the wheel to get the main to turn much. Any tips? Low on hydraulic fluid?
View attachment 78114View attachment 78115View attachment 78116
I have the Garmin 1042 came with the built in map. Been fine for me. The next map chip up just isn’t needed in my opinion. They have a even newer map chip out now, not much betterWent for my first burn in 6 months. Ran like a topGot her up to 48Mph.
really impressed with the detail of the Garmin map out of the box. I don’t see a need for a map chip. @Aquaholic
Everything is amazing except it’s taking lots of turns of the wheel to get the main to turn much. Any tips? Low on hydraulic fluid?
View attachment 78114View attachment 78115View attachment 78116
probably have air in your steering system, just top it up and bleed it and you will be fineWent for my first burn in 6 months. Ran like a topGot her up to 48Mph.
really impressed with the detail of the Garmin map out of the box. I don’t see a need for a map chip. @Aquaholic
Everything is amazing except it’s taking lots of turns of the wheel to get the main to turn much. Any tips? Low on hydraulic fluid?
View attachment 78114View attachment 78115View attachment 78116
His might have it already too. At start up, the screen will say the software version (currently 19.20) and if Bluechart G3 is already installed.I have the Garmin 1042 came with the built in map. Been fine for me. The next map chip up just isn’t needed in my opinion. They have a even newer map chip out now, not much better
that’s your boat? nice!! see it all the time!Putting the bits and bobs back on after a twenty year refit. Re& re engine and leg. Engine refresh at Advanced Marine. Sandblast, prime and paint the topsides.
All pretty on the inside too.
Do you think you’ll ever clean fish on it, or is it just for a bait table, flashers lures etc.