Need ideas to cover deck hole

[Rex4deo]

Does anyone have any suggestions on how I can cover this deck hole? I removed a pedestal seat and found this underneath. The dimensions don't align with any standard deck plate covers. Short of custom making a stainless steel plate, I can't think of anything else.

Sent from my iPad using Tapatalk

 

[Derby]

Go To industry plastics and get them to custom cut a plastic cover to fit that..or fiberglass it over

 

[CIVANO]

http://tempress.com/#!/Deck-Plates/c/610311/offset=0&sort=normal

Check these out. one may fit.

 

[Barnacle Bill]

Looks really good, excellent find. ......BB

 

[casper5280]

I'd go with one of those deck plates CIVANO talking about. Looks like the 8" one will work, you'll have to cut the hole a little larger and I would seal the new cut before I installed it.

 

[Rex4deo]

Yes, I've seen these. But as is said, the dimensions don't align. I would have to cut a larger hole to make the 10 inch plate fit and the 8 inch plate requires a 6 1/2 inch hole. The hole is 6 inches and the screw in holes are 8 inches. I was hoping there is a product out there that is just a flat plate that has the same hole dimensions as the bottom of a standard seat post.

So that is the question... Has anyone seen a product that is a flat stainless or plastic plate with the same dimensions as the bottom of a standard pedestal seat post?


Sent from my iPad using Tapatalk

 

[Derby]

U can get industrial plastics to custom cut a good quality plastic plate to fit.....

 

[KV1]

Why not just get a nice piece of starboard cut it to size drill the holes to match. Sand down the edges to a bevel and presto a removable cover. You could even install some anchor nuts so you would not strip the holes out after to much re and re.

 

[Rex4deo]

Starboard could work and getting something fabricated is always an option. Thanks for the tips.


Sent from my iPad using Tapatalk