These lines can be made up at most hydraulic places where are you located. What size lines 1/2”
Yes they can but the fittings retail at 115 each so 250 per line The line kits sell for 75usd so about 50 cdn per line.
I'll be going that route maybe. Found 2 lines in wisconsin so just 2 to go. Did you get the 316 fittings reasonable?
I was lucky only one fitting had to be replaced and it was pretty reasonable. In my case the hose had just sprung a leak and I had hoped to simply replace the hose. Turned out the one fitting was suspect when they changed the hose and they simply replaced it just in case.
Nope.....ORFS
Haha....nope. i just bought the last one they had but thanks! Still looking for 1 more unicorn kitMercury | HOSE KIT-1 FT | Package Quantity @1 | 32-897982K01
www.mertenmarine.com
Sea star use orfs hose ends. Fitting in cylinder is orb.Nope.....ORFS
ORFS Vs. ORB: What's the Difference - QC Hydraulics
The two most popular hydraulic O-ring fittings are O-ring face seal fittings and O-ring boss fittings. Here's more details.www.qchydraulics.com
My book page 1066 to 1073 shows older seastar being compression and new is only dash 3 ORB for Seastar Dometic so if you've got a part number that would be appreciated. But I don't believe Seastar uses ORFS at all, strictly ORB.
Thanks. I have made steel ones in the short term but they will bleed eventually
I know napa sell orfs hydraulic fittings. Maybe you can special order them and I can crimp em up if you are stuck.
Oh I can get them.....just not paying what they want for stainless ORFS
Stainless ORFS female swivel dash 4
Nope. Not in stainless
