uclueletcharters
Well-Known Member
Twin Optimax for sale with dual binnacle controls
Gen 2 Dual Binnacles with trim switches and 22 or 24 ft cables purchased 2 years ago.
Analog Guages for both
Starboard motor - 2008 ( 835 hrs on the ECM ) Recent shop report shows 125 psi across all 6 cylinders runs great. There was evidence of some water mixed in the leg oil the oil was drained and refilled with fresh oil right away. I believe a prop shaft seal is required as there was some fishing line on the shaft which probably caused some leakage.
Port Motor - 2006 Counter Rotate ( 550 hrs on the ECM ) motor runs but rough compression is all over the place, had alternator just put on prior to this tune up and engine reports. This motor is a rebuild candidate or parts motor. I believe the cause was injector related.
Also included is two 10 L oil reseviors both almost full of DFI and and additional container of 10 L of DFI oil.
Most of the hours are trolling hours.
$6000 for the lot, I can include a set of Mirage props with the sale of the engines
Gen 2 Dual Binnacles with trim switches and 22 or 24 ft cables purchased 2 years ago.
Analog Guages for both
Starboard motor - 2008 ( 835 hrs on the ECM ) Recent shop report shows 125 psi across all 6 cylinders runs great. There was evidence of some water mixed in the leg oil the oil was drained and refilled with fresh oil right away. I believe a prop shaft seal is required as there was some fishing line on the shaft which probably caused some leakage.
Port Motor - 2006 Counter Rotate ( 550 hrs on the ECM ) motor runs but rough compression is all over the place, had alternator just put on prior to this tune up and engine reports. This motor is a rebuild candidate or parts motor. I believe the cause was injector related.
Also included is two 10 L oil reseviors both almost full of DFI and and additional container of 10 L of DFI oil.
Most of the hours are trolling hours.
$6000 for the lot, I can include a set of Mirage props with the sale of the engines
Last edited by a moderator:
