Fisher_dude
Crew Member
Well, it's been quite some time since I was asking question about tables and decided to finally finish the project before my dad goes out to the coast with the boat. Everything is made with 3/16 aluminum as that's all I had at the shop for scrap. I came up with a design based off of what I had to work with. Had the waterjet cut out the bottom and sides and then I cut out the back and the pipe for the bevy holders with the verticle band saw. It was nice welding aluminum again as it's been awhile. I then machined the 1" aluminum round down to snugly fit inside of a Scotty flush mount, cut it in half and put a 3 degree backwards slant to it. Welded it up then put done drain holes in. Came home from work today and, with hole saw in hand, drilled 2 - 1"3/8s holes. Mounted the flush mounts and boom, a working fish/bait table. I'll wait for my dad to get back from the coast and use his feedback on what else to add to it. IE: knife/scissors holder.
