1:34 … I slowed the print down to get better quality. It took me 6 attempts to get the supports correct to print it standing but I finally got it. I am not happy with the nose so I am going to try it lying down tonight and see how it comes out.
Personal use only… if I started selling them I am sure I would be up $hit creek.
just printing an open sourced file.
Most slicing software will allow you enter the filament cost per roll and give an estimate of cost of the print based on the parameters you've asked for. But ya I would say $0.50 would be an overly generous estimate even with some infill.
Only if he sells them and it would take a ton of money to make it stick unless it turned into a competitive business that made a ton of money to make it worth it and it only need to be some small percentage different in design
Nice, what amount of infill are you using?
20% Gyroid infill with 4 perimeter lines.
I want that green one, but I want to put a paint job on it
That would have been smart … I will just print another and compare them.
True, I don’t think they will have a problem. I squished one in the vice and it took way more force than I anticipated.
