should bend back easily enough if you can get the bend in the vise jaws it should bend it back as you tighten flat stock is pretty workable. Don’t give up just yet. Any excessive heat applied will ruin the galvanizing and increase its tendency to bend in the same location, you’ll also be breathing some gross fumes so wear an appropriate respirator if you do heat it up.
Alright, tried again this am with a second set of hands to hold the work bench down as the long snipe was moving it around too easily and got it back to good enough. Also located a spare from this thread as well!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.