I'm in Surrey so the ferry ride would add too much to the cost. Berrys Bait wants $125 plus labour. (that buys a lot of anchovies.)
I don't like to waste stuff so after a week of thought on this tried the best idea that I had. I figured the weight of my car, and the fact that the tires were rubber and wide, would make an ideal press.
I made a jig from some scrap wood I had. I made supports for each end of the tube and put side rails that were just slightly lower than the tube diameter and just a snug fit to the tube size (so that the tube would not roll over when I put pressure on the bend). The jig space was changed for each tube size. I put support under the side rails so that they would not bend down when I drove my car tire onto it. I set the jig, with tube in behind the car tire so that the highest point in the bend was centered under the tire.
Necessity is the mother of all inventions.

