Kingfisher 2025 Escape HT transducer mounting

[Lineman11]

Hi everyone,

I just bought a kingfisher 2025 Escape HT and will be needing to mount the transducer and run the wiring.

Any advice on this? Where to mount it?

If you have pictures that would be great!

Where I should run the wiring? Possibly through the hole that the engine wiring is brought through?

Any help is appreciated

 

[walleyes]

This was on my 2225 but same transom set up. I brought the wire along through wire harness for the engines then drilled a hole in the swim platform large enough to fit the plug through. Set a split rubber grommet in the hole to protect the wire. Then set the transducer on the plate kingfisher has built in the boat. Then a couple stainless screws to holes the zip tie wire holders is place all nice a tidy.

 

[Lineman11]

Is there a fuse box under the dash for power? I haven’t got the boat yet but I assume this is the case for powering the unit! Thank you!