Get A Voltage Charge Off Your Inline Flashers....

[Seafever]

If you are using braid......Run two rotating In-line flashers. the first one will be about 3 to 4 feet back of the clip. The second one will about 2 feet back of the first. In between the two,at the center of your 2 foot line, connect a small piece of flat brass stock about 3 inches long, 1/2 to 3/4 of an inch wide and rounded corners with a hole at each end for sampo swivels/bead chain. Drill a couple holes in the flat stock and affix a washer or two of a different nobility, using stainless bolts and nuts. If the bolt sticks out past the end of the nut, file or grind it down so it's smooth with the end of the nut and no jagged or rough spots (low profile). You could do this with just one inline flasher if you wanted, run about 4 feet back of clip, with the brass plate about a foot ahead of the flasher. Use ample amount of Sampos and bead chain.

 

[Seafever]

Get a Voltage Charge Off Your D/Balls......

If you are running braid.........and if you are using non-coated plain-jane round balls with a bit of a fin on the back of them. Drill a small hole where the fin connects to the ball UNDERNEATH but on the ball itself. Use quite small stainless screw and add a couple of small washers of different nobility. This location will not interfere with ball tracking and will not cause spin. If it does not have fin.....pick the exact bottom of the ball and leave no jagged edges or obstructions. Use a file to smooth out any abberations.