Gelcoat cracking on floor 21ft Ranger Tug

Newf

Crew Member
Last year I started to notice hairline cracking in the floor Gelcoat. I don’t know anything about fibreglass and was wondering what would cause this? Worst location is shown in the photo near the front left engine mount. Not looking to rip the floor out but wondering if there is a coating I could roll or brush on that would slow water/ moisture ingress?
 

Attachments

  • IMG_1357.jpeg
    IMG_1357.jpeg
    477.8 KB · Views: 118
  • IMG_1358.jpeg
    IMG_1358.jpeg
    542.4 KB · Views: 117
Last year I started to notice hairline cracking in the floor Gelcoat. I don’t know anything about fibreglass and was wondering what would cause this? Worst location is shown in the photo near the front left engine mount. Not looking to rip the floor out but wondering if there is a coating I could roll or brush on that would slow water/ moisture ingress?
If you roll or brush anything on it you will not be able to monitor any change. Leave as is and keep an eye on it.
 
Did you reach out to Ranger Tugs? They seem to be a stand up company. A phone call or an email is the lowest cost option


1741115004197.png
 
Did you reach out to Ranger Tugs? They seem to be a stand up company. A phone call or an email is the lowest cost option


View attachment 115119
I have not. I didn’t bother as the boat is over 10 years old and the warranty on the hull was only 5yrs I believe. Probably a good idea to though to see if they have seen this before or had a recommendation of what to do. Thanks. I will reach out to them.
 
Back
Top